Margin Line Tool

Margin line tool

1. Edit mode

Changes the margin line editing mode.

In Point Mode , you can adjust the margin line by dragging control points. Clicking an area without a control point creates a new one, and right-clicking removes it.

When Pen Mode is selected, control points disappear, allowing you to modify the margin line directly by dragging over the scan data.

2. Adjustment

Adjusts the values for uniformly shifting the margin line.

3. Move

Shifts the margin line uniformly by the value set in Adjustment.

4. Redetect

Re-detects the margin line based on the starting position selected by the user.

5. Clear

Deletes the generated margin line. After deletion, you can manually draw the margin line or re-detect it using the Redetect button.

6. Show undercuts

Toggles the visualization of the undercut on the abutment tooth on or off.

7. Show backface

Toggles the transparency of the back side of the selected tooth's mesh on or off.

8. Apply

Updates the generated crown according to the modified margin line.

Caution

The Apply button is only displayed in the modes where a crown has been generated on the abutment tooth or when manually adding an abutment tooth. The Apply button does not appear until the crown is generated.

Margin Manual Setting

Quick Guide

• Manually setting the margin line is only possible in Point Mode.

• The line creation is completed when the last point connects to the starting point.